Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

Interest in an universal Dynamixel device?

Bioloid robot kit from Korean company Robotis; CM5 controller block, AX12 servos..
16 posts • Page 2 of 2 • 1, 2
Post a reply
16 posts • Page 2 of 2 • 1, 2

Would you like a Arduino-compatible universal Dynamixel device?

I want tens of these!
3
60%
I might be interested at some point...
2
40%
Not really interested.
0
No votes
That's useless and dumb!
0
No votes
What?
0
No votes
 
Total votes : 5

Re: Interest in an universal Dynamixel device?

Post by PaulL » Tue Jun 17, 2014 11:48 am

Post by PaulL
Tue Jun 17, 2014 11:48 am

Mine were a little "bumpy", but paste was still OK. I can't imagine trying to do paste by hand, though I know some do without issue. I can do a few components, but with certain chips, I think a stencil makes more sense. But, if one can afford a stencil, even the cheaper mylar ones, I think the cost, even for single board quantities, is well worth it.

Canceled - sorry to hear that, I hope they don't cancel it for next year!

Take Care,
Paul
Mine were a little "bumpy", but paste was still OK. I can't imagine trying to do paste by hand, though I know some do without issue. I can do a few components, but with certain chips, I think a stencil makes more sense. But, if one can afford a stencil, even the cheaper mylar ones, I think the cost, even for single board quantities, is well worth it.

Canceled - sorry to hear that, I hope they don't cancel it for next year!

Take Care,
Paul
PaulL
Savvy Roboteer
Savvy Roboteer
Posts: 423
Joined: Sat Sep 15, 2007 12:52 am
Top
Previous
16 posts • Page 2 of 2 • 1, 2
Post a reply
16 posts • Page 2 of 2 • 1, 2
Return to Bioloid & Robotis