Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

How to reset AX-12A on linux?

Bioloid robot kit from Korean company Robotis; CM5 controller block, AX12 servos..
1 post • Page 1 of 1
Post a reply
1 post • Page 1 of 1

How to reset AX-12A on linux?

Post by talia_xu » Mon Jun 16, 2014 6:22 pm

Post by talia_xu
Mon Jun 16, 2014 6:22 pm

Hi guys, I recently got a robotic arm

http://www.crustcrawler.com/products/AX ... tic%20Arm/

but thought that two of the servos may be corrupted (the LEDs are always on and I couldn't find their IDs)

I am on linux, so I couldn't use Dynamixel Wizard to restore the settings, I'm wondering if anyone would have an idea how I could possibly reset them on linux? (I have the driver installed)

Thanks!
Hi guys, I recently got a robotic arm

http://www.crustcrawler.com/products/AX ... tic%20Arm/

but thought that two of the servos may be corrupted (the LEDs are always on and I couldn't find their IDs)

I am on linux, so I couldn't use Dynamixel Wizard to restore the settings, I'm wondering if anyone would have an idea how I could possibly reset them on linux? (I have the driver installed)

Thanks!
talia_xu
Newbie
Newbie
Posts: 1
Joined: Mon Jun 16, 2014 6:19 pm
Top
1 post • Page 1 of 1
Post a reply
1 post • Page 1 of 1
Return to Bioloid & Robotis