Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

Can I use the contol program to activate an electro-magnet?

Bioloid robot kit from Korean company Robotis; CM5 controller block, AX12 servos..
3 posts • Page 1 of 1
Post a reply
3 posts • Page 1 of 1

Can I use the contol program to activate an electro-magnet?

Post by yyy » Wed Dec 19, 2007 6:10 pm

Post by yyy
Wed Dec 19, 2007 6:10 pm

I purchased a comprehansive kit.
I want to activate an electro-magnet, when reaching a specific robot configuration.
Can I use the program supplied?
Can I use the cm5?
Can I send a program written in C++ or Labview, to the cm5?
thanks.
I purchased a comprehansive kit.
I want to activate an electro-magnet, when reaching a specific robot configuration.
Can I use the program supplied?
Can I use the cm5?
Can I send a program written in C++ or Labview, to the cm5?
thanks.
yyy
Newbie
Newbie
Posts: 1
Joined: Wed Dec 19, 2007 6:02 pm
Top

Post by Robo1 » Wed Dec 19, 2007 11:13 pm

Post by Robo1
Wed Dec 19, 2007 11:13 pm

Hi there

I want to activate an electro-magnet, when reaching a specific robot configuration.


How is it activated! e.g. what interface.

Bren
Hi there

I want to activate an electro-magnet, when reaching a specific robot configuration.


How is it activated! e.g. what interface.

Bren
Robo1
Savvy Roboteer
Savvy Roboteer
Posts: 501
Joined: Fri Jun 30, 2006 1:00 am
Location: UK - Bristol
Top

Re: Can I use the contol program to activate an electro-magn

Post by siempre.aprendiendo » Thu Dec 20, 2007 9:55 am

Post by siempre.aprendiendo
Thu Dec 20, 2007 9:55 am

yyy wrote:I purchased a comprehansive kit.
I want to activate an electro-magnet, when reaching a specific robot configuration.
Can I use the program supplied?
Can I use the cm5?
Can I send a program written in C++ or Labview, to the cm5?
thanks.


How do you activate it?

You can use C++ but with some important limitations
yyy wrote:I purchased a comprehansive kit.
I want to activate an electro-magnet, when reaching a specific robot configuration.
Can I use the program supplied?
Can I use the cm5?
Can I send a program written in C++ or Labview, to the cm5?
thanks.


How do you activate it?

You can use C++ but with some important limitations
siempre.aprendiendo
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 559
Joined: Wed Aug 08, 2007 9:13 pm
Location: Barcelona
Top

3 posts • Page 1 of 1
Post a reply
3 posts • Page 1 of 1
Return to Bioloid & Robotis