Mounting the Zig-100
Mounting the Zig-100
by srobot
Thu Jan 10, 2008 8:58 pm
I'm going to solder in the Zig-100, but I can't figure out how to place it.
I see the spot, and side, but does the Zig-100 go in with long bar on the back matching the X-Tal on the CM-5, or should the X-Tal be on the bottom and the bar on the top?
Another way of saying this is, does the square hole on Zig-100 match the one on the CM-5 or not?
--Scotty
I see the spot, and side, but does the Zig-100 go in with long bar on the back matching the X-Tal on the CM-5, or should the X-Tal be on the bottom and the bar on the top?
Another way of saying this is, does the square hole on Zig-100 match the one on the CM-5 or not?
--Scotty
Dell Latitude D520, Windows XP, 4 GB RAM, 80 GB HDD, Intel Core 2 Duo. The power that's needed!
RIBO Labs, Springing Robotic Development to a New Level
RIBO Labs, Springing Robotic Development to a New Level
by srobot
Thu Jan 10, 2008 9:37 pm
I just saw that they show how to mount the Zig-100 at the bottom of page 96 in the Users Guide.
Dell Latitude D520, Windows XP, 4 GB RAM, 80 GB HDD, Intel Core 2 Duo. The power that's needed!
RIBO Labs, Springing Robotic Development to a New Level
RIBO Labs, Springing Robotic Development to a New Level