S.O.S. Hex file

[Andi]

Hi All,

sorry for posting, but I am really frustrated now, I have changed the hex file to another file atmega128-pc-bioloid.hex and now I want to change back to the standard Bioloid_Ver115.hex and simply cant.

I took the routine which was posted here (taking the Bioloid terminal and pressing # before powering the CM-5, but I have no respones whatsoever from the CM-5. I cannot enter the boot loader I guess.

The POWER Led is blinking permanently and I have no clue what to do now to change back to the old hex.

Does anybody have any ideas what to do?

Many thanks

Andi

[siempre.aprendiendo]

Hi All,

sorry for posting, but I am really frustrated now, I have changed the hex file to another file atmega128-pc-bioloid.hex and now I want to change back to the standard Bioloid_Ver115.hex and simply cant.

I took the routine which was posted here (taking the Bioloid terminal and pressing # before powering the CM-5, but I have no respones whatsoever from the CM-5. I cannot enter the boot loader I guess.

The POWER Led is blinking permanently and I have no clue what to do now to change back to the old hex.

Does anybody have any ideas what to do?

Many thanks

Andi

Once that you have powered on the CM-5 holding "#" (usually some "#" appears at the boot loader prompt) you should type load, then, in the file menu, select receive file and pick the bioloid-ver115 file

If you are low on battery you can use it with the battery connector plugged

I think that almost everybody have had the same "problem"

[Andi]

Hi

many thanks for your answer.

I tried this, but when I am opening the Bioloid terminal, I cannot type in anything at all...

Is there any way to reset the CM-5 and then to enter the boot loader OR is there any other way to enter the boot loader at all???

Best wishes

Andi