Recovering Hex file with Behavior Control Programmer
Recovering Hex file with Behavior Control Programmer
by Andi
Sat Feb 09, 2008 12:22 pm
Hi,
I tried yesterday to recover the hex file of the CM-5 as I loaded one into it and could not connect to the CM-5 at all.
After some hours of trying it with the Robot Terminal and following the guidelines in the forum I finally downloaded the new Bioloid software 1.10.
Included is the Behavior Control Programmer 1.23
And in this version there is a new functionality which was missing in the older version.
If you go to MANAGEMENT and then hit RECOVERY CM-5 you are guided through a menue and the CM-5 is then updated to any hex file you want. It took 1 minute or so and then it worked.
Best wishes
Andi
I tried yesterday to recover the hex file of the CM-5 as I loaded one into it and could not connect to the CM-5 at all.
After some hours of trying it with the Robot Terminal and following the guidelines in the forum I finally downloaded the new Bioloid software 1.10.
Included is the Behavior Control Programmer 1.23
And in this version there is a new functionality which was missing in the older version.
If you go to MANAGEMENT and then hit RECOVERY CM-5 you are guided through a menue and the CM-5 is then updated to any hex file you want. It took 1 minute or so and then it worked.
Best wishes
Andi
