Kill a dynamixels ?
Kill a dynamixels ?
by boutboutnico
Thu Feb 14, 2008 7:43 pm
Hi all,
Is it possible to kill a dynamixel? I have no answer from this one. I have try to reset the ax-12, set a new ID check wire connector etc...
Help is welcome
Nico
Is it possible to kill a dynamixel? I have no answer from this one. I have try to reset the ax-12, set a new ID check wire connector etc...
Help is welcome
Nico
Re: Kill a dynamixels ?
by siempre.aprendiendo
Thu Feb 14, 2008 9:30 pm
boutboutnico wrote:Hi all,
Is it possible to kill a dynamixel? I have no answer from this one. I have try to reset the ax-12, set a new ID check wire connector etc...
Help is welcome
Nico
From another thread you said there was error 8100
Well, from the user's manual:
Code = 8100
Meaning = Access to the unavailable Dynamixel ID
Check Point = Check whether an using ID of AX-12+ or AX-S1 that does not exist ist in robot. Check the cutting line
You can download this manual from:
"http://211.238.207.44/~robotis/ROBOTIS/Manual/BioloidUsersGuide(ver1-1)EN.zip"
The other more common problem is have changed unintentionally baud or id parameters from one or more AX12+
