Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

Zig-bee Configuration

Bioloid robot kit from Korean company Robotis; CM5 controller block, AX12 servos..
1 post • Page 1 of 1
Post a reply
1 post • Page 1 of 1

Zig-bee Configuration

Post by JavaRN » Tue Feb 19, 2008 7:46 pm

Post by JavaRN
Tue Feb 19, 2008 7:46 pm

As I already posted I managed to setup the Zig-bee hardware. I wrote a small utility in java that accepts input from zig-bee port (in my case it is port 16). The problem is that I am receiving a lot of packets (a 50 or so), not just one. So I am thinking that probably the Zig-bee module is operating in broadcasting mode. How can I adjust it so that it transmits "peer-to-peer".

Note I tried through the Robot terminal program, but I don't get the Zig-bee module configuration interface (the one you type '!' for configuration).

Any help is appreciated.

Charles
As I already posted I managed to setup the Zig-bee hardware. I wrote a small utility in java that accepts input from zig-bee port (in my case it is port 16). The problem is that I am receiving a lot of packets (a 50 or so), not just one. So I am thinking that probably the Zig-bee module is operating in broadcasting mode. How can I adjust it so that it transmits "peer-to-peer".

Note I tried through the Robot terminal program, but I don't get the Zig-bee module configuration interface (the one you type '!' for configuration).

Any help is appreciated.

Charles
F'dan il-passatemp ghandek bzonn zewg affarijiet - FLUS u HIN. Zewg affarijiet li huma skarsi hafna u li jien minnhom ghandi vera ftit!
JavaRN
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 282
Joined: Fri Mar 02, 2007 11:01 pm
Top
1 post • Page 1 of 1
Post a reply
1 post • Page 1 of 1
Return to Bioloid & Robotis