Humanoid...Invalid Page Read:0001
Humanoid...Invalid Page Read:0001
by Help
Sat May 24, 2008 8:42 pm
Hey Guys just completed my first Humanoid robot from the Bioloid Comprehensive Kit...And the CheckAssembly program from the BCP runs as instructed and he ends in the proper manner.
After this i tried to run the DemoExample and am getting the following message
It reads all of the dynamixles then says the following:
019(0X13) Dynamixles found. [Invalid Page Read:0001]
When i his L which is supposed to enter fighting stance the robot reads:
Invalid Page Read: 002A or 002B depending on the side I put my hand...It does this about 100 times
any help would be appreciated
After this i tried to run the DemoExample and am getting the following message
It reads all of the dynamixles then says the following:
019(0X13) Dynamixles found. [Invalid Page Read:0001]
When i his L which is supposed to enter fighting stance the robot reads:
Invalid Page Read: 002A or 002B depending on the side I put my hand...It does this about 100 times
any help would be appreciated
by limor
Sat May 24, 2008 11:54 pm
searching on the forum Invalid Page Read came up with this thread:
http://robosavvy.com/forum/viewtopic.ph ... valid+read
could it be that you have a fuse problem ?
http://robosavvy.com/forum/viewtopic.ph ... valid+read
could it be that you have a fuse problem ?
by StuartL
Sun May 25, 2008 7:30 am
As per this post here:
http://robosavvy.com/forum/viewtopic.php?t=2579
This problem is the absence of motion data in the CM-5 memory. Upload the motion data and all will be well.
http://robosavvy.com/forum/viewtopic.php?t=2579
This problem is the absence of motion data in the CM-5 memory. Upload the motion data and all will be well.