Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

Robot Terminal problem

Bioloid robot kit from Korean company Robotis; CM5 controller block, AX12 servos..
2 posts • Page 1 of 1
Post a reply
2 posts • Page 1 of 1

Robot Terminal problem

Post by xyz123456 » Tue Jul 08, 2008 8:30 am

Post by xyz123456
Tue Jul 08, 2008 8:30 am

Hi,
I am using Robot terminal V0.9 for programming Atmega128. The default baud rate for communication via serial port is 57600bps. When i try to change the baud rate to 115200bps , I am not able to program the Atmega 128. :( .Could anyone anyone help me with this problem.

Thanks in advance.
Hi,
I am using Robot terminal V0.9 for programming Atmega128. The default baud rate for communication via serial port is 57600bps. When i try to change the baud rate to 115200bps , I am not able to program the Atmega 128. :( .Could anyone anyone help me with this problem.

Thanks in advance.
xyz123456
Newbie
Newbie
Posts: 3
Joined: Tue Jul 08, 2008 8:27 am
Top

Post by siempre.aprendiendo » Tue Jul 08, 2008 8:19 pm

Post by siempre.aprendiendo
Tue Jul 08, 2008 8:19 pm

I suppose you are using the CM-5 and the default Bioloid software, isn't it?

If this is the case, at least for my knowledge, the software is configured to use only 57600.
I suppose you are using the CM-5 and the default Bioloid software, isn't it?

If this is the case, at least for my knowledge, the software is configured to use only 57600.
siempre.aprendiendo
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 559
Joined: Wed Aug 08, 2007 9:13 pm
Location: Barcelona
Top

2 posts • Page 1 of 1
Post a reply
2 posts • Page 1 of 1
Return to Bioloid & Robotis