Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

Why are AX-12 Dynamixels not moving?

Bioloid robot kit from Korean company Robotis; CM5 controller block, AX12 servos..
2 posts • Page 1 of 1
Post a reply
2 posts • Page 1 of 1

Why are AX-12 Dynamixels not moving?

Post by yap » Mon Nov 17, 2008 6:21 am

Post by yap
Mon Nov 17, 2008 6:21 am

I was trying out Bioloid humanoid robot by writing a short and simple program of moving all dynamixels to their centre position. The program was fine, no error. But, when i play the program, the dynamixels were not moving at all. Why is this so?
I was trying out Bioloid humanoid robot by writing a short and simple program of moving all dynamixels to their centre position. The program was fine, no error. But, when i play the program, the dynamixels were not moving at all. Why is this so?
yap
Newbie
Newbie
Posts: 2
Joined: Mon Nov 17, 2008 6:16 am
Top

Post by Robo1 » Mon Nov 17, 2008 5:06 pm

Post by Robo1
Mon Nov 17, 2008 5:06 pm

could you post code nad more details, you comment doesn't give any details, have you been able to move the servo's before have you tried any of the demo files.

Bren
could you post code nad more details, you comment doesn't give any details, have you been able to move the servo's before have you tried any of the demo files.

Bren
Robo1
Savvy Roboteer
Savvy Roboteer
Posts: 501
Joined: Fri Jun 30, 2006 1:00 am
Location: UK - Bristol
Top

2 posts • Page 1 of 1
Post a reply
2 posts • Page 1 of 1
Return to Bioloid & Robotis