Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

M2 screwdriver

Bioloid robot kit from Korean company Robotis; CM5 controller block, AX12 servos..
2 postsPage 1 of 1
2 postsPage 1 of 1

M2 screwdriver

Post by Nemo » Sat Mar 07, 2009 1:35 am

Post by Nemo
Sat Mar 07, 2009 1:35 am

Hi guys,

I just bought a Bioloid and I was preparing myself for its arrival by reading the manual :shock:

It says there that I need an Philips M2 screwdriver... Did you build your Bioloid with an M2? Is M2 0.95mm? Where did you get it from, cause no matter how much I look around I cannot find one to buy...

Is a standard 0.75mm going to do the job? I was reading an article that the screwdriver does make a difference (http://www.botmag.com/forum/showthread. ... 76#post576). Does it really???
Hi guys,

I just bought a Bioloid and I was preparing myself for its arrival by reading the manual :shock:

It says there that I need an Philips M2 screwdriver... Did you build your Bioloid with an M2? Is M2 0.95mm? Where did you get it from, cause no matter how much I look around I cannot find one to buy...

Is a standard 0.75mm going to do the job? I was reading an article that the screwdriver does make a difference (http://www.botmag.com/forum/showthread. ... 76#post576). Does it really???
Nemo
Newbie
Newbie
Posts: 1
Joined: Sat Mar 07, 2009 1:24 am

Post by StuartL » Tue Mar 10, 2009 8:47 am

Post by StuartL
Tue Mar 10, 2009 8:47 am

I use the JST screwdrivers I imported from the US. You don't see them in the UK very often but you may have some luck googling. They fit the screw heads perfectly :)
I use the JST screwdrivers I imported from the US. You don't see them in the UK very often but you may have some luck googling. They fit the screw heads perfectly :)
StuartL
Savvy Roboteer
Savvy Roboteer
Posts: 350
Joined: Mon Jun 04, 2007 3:46 pm
Location: Thatcham, Berkshire, UK


2 postsPage 1 of 1
2 postsPage 1 of 1