Why is this happening?
by mpenoushliev
Mon May 18, 2009 5:00 pm
Yes I had some troubles with that as well, to add the new servos to the motion editor you should open the robot file you are using and in the motor number section you should type 21 e.g.:
3D file:humanoid.x
Motor Number:21
0:1:[1]Dynamixel:512
................................
And now for the fun part apparently the joint angle window in motion editor can only fit 19 entries there is no scroll option!!!! So you`ll see part of servo 20 and will not see servo 21. I wrote to robotis about this issue but still no reply. Here`s my topic:
http://robotis.com/zbxe/31009#0
3D file:humanoid.x
Motor Number:21
0:1:[1]Dynamixel:512
................................
And now for the fun part apparently the joint angle window in motion editor can only fit 19 entries there is no scroll option!!!! So you`ll see part of servo 20 and will not see servo 21. I wrote to robotis about this issue but still no reply. Here`s my topic:
http://robotis.com/zbxe/31009#0
