wireless comunication problem between cm-5 and zig2serial
wireless comunication problem between cm-5 and zig2serial
by Jeeves
Wed Jul 08, 2009 7:03 pm
I am using the zig100 module. When I send a data from CM-5 to PC is working correctly, but from PC to CM-5 don't.
I am using the example program of the Behavior Control Programmer. The CM-5 RXD led blink when I send the message from PC, but the program don't responds.
Can someone help me to understand what is happening?
I am using the example program of the Behavior Control Programmer. The CM-5 RXD led blink when I send the message from PC, but the program don't responds.
Can someone help me to understand what is happening?
by kamondelious
Wed Jul 15, 2009 2:41 pm
Hi Jeeves,
You might want to read over this thread, if you haven't already.
http://robosavvy.com/forum/viewtopic.php?t=1395
The example program is most likely sending the packets from CM5->PC correctly, whereas you may not be when you try to connect from PC->CM5.
The RXD LED will blink because you're sending data. Maybe you need to modify the example program to blink the LEDs on the Bioloid when it receives data to help troubleshoot this.
You might want to read over this thread, if you haven't already.
http://robosavvy.com/forum/viewtopic.php?t=1395
The example program is most likely sending the packets from CM5->PC correctly, whereas you may not be when you try to connect from PC->CM5.
The RXD LED will blink because you're sending data. Maybe you need to modify the example program to blink the LEDs on the Bioloid when it receives data to help troubleshoot this.
