Help! Motion Editor Ax-12 problem.
Help! Motion Editor Ax-12 problem.
by real88
Sat Jul 25, 2009 10:55 am
Hi all,
I facing a problem about the Bioloid Motion Editor, since i change the rbt file to Humanoid(19DOF), While i on the servo motor , almost all motors are turn into 1023 automatic some are 0 angle. and not tuning base on wat the Bioloid motion i desire.
Izit the firmware problem, but i hv try Bioloid v110.hex and Bioloid v115.hex still getting this problem. besides, can bootloader help to reset back to original by using flash or clear?
Any can give some guide to solve this problem.
Thx.
I facing a problem about the Bioloid Motion Editor, since i change the rbt file to Humanoid(19DOF), While i on the servo motor , almost all motors are turn into 1023 automatic some are 0 angle. and not tuning base on wat the Bioloid motion i desire.
Izit the firmware problem, but i hv try Bioloid v110.hex and Bioloid v115.hex still getting this problem. besides, can bootloader help to reset back to original by using flash or clear?
Any can give some guide to solve this problem.
Thx.
