Problem with additional AX-12
Problem with additional AX-12
by The Spanish Robot
Wed Feb 03, 2010 1:32 pm
Hi.
I´ve got problem with a additional servo that I bought for my bioloid Comprehensive kit so I use CM-5 controller
I set this servo with id=19
When I use RoboPlus Manager I can move this servo correctly .I chage the value of the goal position and the servo works ok
The problem is when I use RoboPlus motion. The servo always takes value 1023 and I can´t move it from this position, I try change the value but it never move…
I hope you can help me because I don’t know what to do.
Thanks!!
I´ve got problem with a additional servo that I bought for my bioloid Comprehensive kit so I use CM-5 controller
I set this servo with id=19
When I use RoboPlus Manager I can move this servo correctly .I chage the value of the goal position and the servo works ok
The problem is when I use RoboPlus motion. The servo always takes value 1023 and I can´t move it from this position, I try change the value but it never move…
I hope you can help me because I don’t know what to do.
Thanks!!
