Help needed in Libftdi

[NEVER]

I am trying to send data packets to my RX-64 motor using Libftdi... but it is giving the following error...

"usb 1-1.3.1: BOGUS urb flags, 1 --> 0"

Pls Help asap....

[Bullit]

You'd need to provide me with more details. I'm not familiar with that error.
Does this occur when opening the port? Post more code fragments and I'll try to help.

[NEVER]

Error comes when we run the code on gumstix --- uname -a "Linux overo 2.6.32 armv7l GNU/Linux"
While everything runs as expected on Host system.

following is the trace that comes after running the default "baud_test" example of "Lib-ftdi0.17"

------------------------------------------------------------------------------------
ftdi_sio ttyUSB0: FTDI USB Serial Device converter now disconnected from ttyUSB0
ftdi_sio 1-1.3.1:1.0: device disconnected
real baudrate used: 9600usb 1-1.3.1: BOGUS urb flags, 1 --> 0

this test should take 10.42 seconds
write failed at 0: usb bulk write failed
------------------------------------------------------------------------------------

[Bullit]

I haven't experienced this issue myself. I'll have to check which version I'm using. I did however find this that you may find useful.
The nice thing about open source code is you can drill right down to where the problem is.