Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

Question on Present load in dynamixel.

Bioloid robot kit from Korean company Robotis; CM5 controller block, AX12 servos..
1 post • Page 1 of 1
Post a reply
1 post • Page 1 of 1

Question on Present load in dynamixel.

Post by rikkov » Thu Apr 08, 2010 6:38 am

Post by rikkov
Thu Apr 08, 2010 6:38 am

Hi Guys,

I use Rx serise dynamixel.

It would be really helpful if someone could give me some insight on the present load value given out by dynamixel.

Is this present load calculated using the current(amps) value? I would also like to know that how it is infered that the servos is overloaded by dynamixel.

Thanks a lot,
Rikkov
Hi Guys,

I use Rx serise dynamixel.

It would be really helpful if someone could give me some insight on the present load value given out by dynamixel.

Is this present load calculated using the current(amps) value? I would also like to know that how it is infered that the servos is overloaded by dynamixel.

Thanks a lot,
Rikkov
rikkov
Robot Builder
Robot Builder
Posts: 15
Joined: Wed Aug 27, 2008 4:11 am
Top
1 post • Page 1 of 1
Post a reply
1 post • Page 1 of 1
Return to Bioloid & Robotis