zig problem
zig problem
by mefmef
Wed Aug 11, 2010 8:32 pm
hi every body
i a funny problem , when i connect rx to tx in cm-5 and run the program in behavior witch load a number on tx and print rx it works (the same number recive on rx )
but the same program on roboplus does not work and nothing recive via rx!
is any body now why? and how can i fix this?
i a funny problem , when i connect rx to tx in cm-5 and run the program in behavior witch load a number on tx and print rx it works (the same number recive on rx )
but the same program on roboplus does not work and nothing recive via rx!
is any body now why? and how can i fix this?
by Fritzoid
Mon Aug 23, 2010 1:50 pm
mefmef,
I don't have a CM-5 or the older BCP program so I can't run this test. However, I can suggest you look into the RUN command (executable from manage mode). You can use it to step through a program running on the CM-5 one token at a time. It might help you find out what's going on.
I don't have a CM-5 or the older BCP program so I can't run this test. However, I can suggest you look into the RUN command (executable from manage mode). You can use it to step through a program running on the CM-5 one token at a time. It might help you find out what's going on.
