Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

Power Supply

Bioloid robot kit from Korean company Robotis; CM5 controller block, AX12 servos..
4 posts • Page 1 of 1
Post a reply
4 posts • Page 1 of 1

Power Supply

Post by Peverel » Fri Oct 29, 2010 3:19 pm

Post by Peverel
Fri Oct 29, 2010 3:19 pm

Could someone have a look at the Bioloid Power supply and tell me the output spec please.

I have dug my bioloid out of retirement and have mis-placed the power supply so need to try and get another one. I have found a 12volt 4amp unit but want to check that the output is ok. I am pretty sure that the old power brick was 12 volt just not sure of the ampage rating.

Many Thanks

Pev
Could someone have a look at the Bioloid Power supply and tell me the output spec please.

I have dug my bioloid out of retirement and have mis-placed the power supply so need to try and get another one. I have found a 12volt 4amp unit but want to check that the output is ok. I am pretty sure that the old power brick was 12 volt just not sure of the ampage rating.

Many Thanks

Pev
Peverel
Newbie
Newbie
Posts: 2
Joined: Wed Oct 27, 2010 11:12 pm
Top

Power supply

Post by bluecat » Fri Oct 29, 2010 4:18 pm

Post by bluecat
Fri Oct 29, 2010 4:18 pm

Its 5A =)

cheers
Its 5A =)

cheers
bluecat
Robot Builder
Robot Builder
Posts: 24
Joined: Wed Jun 16, 2010 5:45 pm
Top

Post by billyzelsnack » Fri Oct 29, 2010 4:34 pm

Post by billyzelsnack
Fri Oct 29, 2010 4:34 pm

12V 5A center positive.
12V 5A center positive.
billyzelsnack
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 618
Joined: Sat Dec 30, 2006 1:00 am
Top

Post by Peverel » Fri Oct 29, 2010 8:33 pm

Post by Peverel
Fri Oct 29, 2010 8:33 pm

Thank you both,

I have now purchased a 12v 90W (7.5amp) power brick and the old Bioloid is back up and kicking :D
Thank you both,

I have now purchased a 12v 90W (7.5amp) power brick and the old Bioloid is back up and kicking :D
Peverel
Newbie
Newbie
Posts: 2
Joined: Wed Oct 27, 2010 11:12 pm
Top

4 posts • Page 1 of 1
Post a reply
4 posts • Page 1 of 1
Return to Bioloid & Robotis