reset cm-5
reset cm-5
by evyg11
Wed Nov 03, 2010 11:51 am
Hi!
I have bioloid with cm-5. I try to connect it to the computer but when i turn on the cm-5 only the power LED turn on and the other leds include mode and start are dead. I tryed to recover the cm-5 from BCP but it says that the recover is failed. How can I reset cm-5? Thanks
I have bioloid with cm-5. I try to connect it to the computer but when i turn on the cm-5 only the power LED turn on and the other leds include mode and start are dead. I tryed to recover the cm-5 from BCP but it says that the recover is failed. How can I reset cm-5? Thanks
by Fritzoid
Wed Nov 03, 2010 7:37 pm
The key question is...can you get into the bootloader?
Use RoboPlus terminal or similar program and connect to the CM-5 at 56kbs. Hold down the shift and number sign (#) keys on the computer with one hand then turn on the CM-5 with the other hand.
If the bootloader message comes up there's hope. If not then it's time for a new controller.
Use RoboPlus terminal or similar program and connect to the CM-5 at 56kbs. Hold down the shift and number sign (#) keys on the computer with one hand then turn on the CM-5 with the other hand.
If the bootloader message comes up there's hope. If not then it's time for a new controller.
