Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

Connect RX and EX series to CM510

Bioloid robot kit from Korean company Robotis; CM5 controller block, AX12 servos..
3 posts • Page 1 of 1
Post a reply
3 posts • Page 1 of 1

Connect RX and EX series to CM510

Post by Teng » Sun Nov 07, 2010 10:05 am

Post by Teng
Sun Nov 07, 2010 10:05 am

RX and EX use RS485 while AX uses TTL and CM510 only has TTL. Is there already or is someone thinking of coming out with something to enable RS485 and allow for more sensors to be used with CM510?

There is most likely to have lots of demand for it.
RX and EX use RS485 while AX uses TTL and CM510 only has TTL. Is there already or is someone thinking of coming out with something to enable RS485 and allow for more sensors to be used with CM510?

There is most likely to have lots of demand for it.
Teng
Newbie
Newbie
Posts: 5
Joined: Fri Feb 19, 2010 5:28 am
Top

Post by UncleBob » Sun Nov 07, 2010 12:35 pm

Post by UncleBob
Sun Nov 07, 2010 12:35 pm

Which is why you need cm700. Also rx draws a lot of current not sure if cm510 can handle.
Which is why you need cm700. Also rx draws a lot of current not sure if cm510 can handle.
UncleBob
Savvy Roboteer
Savvy Roboteer
Posts: 398
Joined: Sun Dec 27, 2009 5:25 am
Top

Post by Teng » Sun Nov 07, 2010 12:45 pm

Post by Teng
Sun Nov 07, 2010 12:45 pm

Wouldn't it not be good to have some open-sourced design to get AX, RX and EX to work with CM510. Is such a pity to use CM510 for only AX.

Just a wild idea.
Wouldn't it not be good to have some open-sourced design to get AX, RX and EX to work with CM510. Is such a pity to use CM510 for only AX.

Just a wild idea.
Teng
Newbie
Newbie
Posts: 5
Joined: Fri Feb 19, 2010 5:28 am
Top

3 posts • Page 1 of 1
Post a reply
3 posts • Page 1 of 1
Return to Bioloid & Robotis