Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

Zig110/Zig100 connection issues

Bioloid robot kit from Korean company Robotis; CM5 controller block, AX12 servos..
1 post • Page 1 of 1
Post a reply
1 post • Page 1 of 1

Zig110/Zig100 connection issues

Post by Pev » Fri Dec 03, 2010 12:46 am

Post by Pev
Fri Dec 03, 2010 12:46 am

I have just received my RC100Z setup and got the ZIG link all working. The only issue I have is that the connection keeps dropping over the shortest distances.

I get the initial connection with no issues. Then if I move the remote more than about 2 feet or so away the red light on the Zig110 flashes really fast and the connection drops. I have to move the remote to about a foot away from the Zig110 to get it to reconnect.

Anyone have any suggestions as to what I can do to improve the range?

Thanks

Pev
I have just received my RC100Z setup and got the ZIG link all working. The only issue I have is that the connection keeps dropping over the shortest distances.

I get the initial connection with no issues. Then if I move the remote more than about 2 feet or so away the red light on the Zig110 flashes really fast and the connection drops. I have to move the remote to about a foot away from the Zig110 to get it to reconnect.

Anyone have any suggestions as to what I can do to improve the range?

Thanks

Pev
Pev
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 547
Joined: Sun Feb 26, 2006 1:00 am
Location: UK
Top
1 post • Page 1 of 1
Post a reply
1 post • Page 1 of 1
Return to Bioloid & Robotis