Connection impossible with CM-5 with Roboplus motion

[lau]

Hello
Sorry for the bad writing of English that I know very very bad, I speak french with my tongue cons chart.
Here is my problem I pocede Bioloid comprehensive kit for what I directly installed the robot, and my problem is I connect my CM5 converted by the serial cable with USB and well recognized on the PC (Windows 7) as port 8 no worries on that side when I run the connection with the motion software Roboplus I can clearly see the LEDs TXD and RXD on the CM-5 program and then flashed an error message asking me if the robot is turning on whether the port is the right etc. ..

I hope you understand my message translated by Google translation only way for me to make myself understood in English

Thank you in advance for your help

[lau]

Hello
I managed to find it because I could get the instructions in French on another website.
And it should update the firmware, the software Roboplus manager.
This message will perhaps someone else has
@ Bientot