Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

Bioloid Demo at New York Toy Fair 2011

Bioloid robot kit from Korean company Robotis; CM5 controller block, AX12 servos..
5 posts • Page 1 of 1
Post a reply
5 posts • Page 1 of 1

Bioloid Demo at New York Toy Fair 2011

Post by Gort » Sat Feb 19, 2011 3:12 am

Post by Gort
Sat Feb 19, 2011 3:12 am

phpBB [media]


http://mike-ibioloid.blogspot.com/2011/ ... obots.html

phpBB [media]


http://mike-ibioloid.blogspot.com/2011/ ... -demo.html
phpBB [media]


http://mike-ibioloid.blogspot.com/2011/ ... obots.html

phpBB [media]


http://mike-ibioloid.blogspot.com/2011/ ... -demo.html
Gort
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 555
Joined: Wed May 31, 2006 1:00 am
Location: KC, MO, USA
Top

Post by Fritzoid » Tue Feb 22, 2011 12:09 pm

Post by Fritzoid
Tue Feb 22, 2011 12:09 pm

Nice video Gort.

You could probably do this using a PC to send commands over a zigbee link in broadcast mode. All the robots receive the same command at the same time, so they run the motions in concert.
Nice video Gort.

You could probably do this using a PC to send commands over a zigbee link in broadcast mode. All the robots receive the same command at the same time, so they run the motions in concert.
Fritzoid
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 331
Joined: Mon Dec 18, 2006 1:00 am
Top

Post by Gort » Tue Feb 22, 2011 6:39 pm

Post by Gort
Tue Feb 22, 2011 6:39 pm

This was done using bluetooth!
This was done using bluetooth!
Gort
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 555
Joined: Wed May 31, 2006 1:00 am
Location: KC, MO, USA
Top

Post by siempre.aprendiendo » Tue Feb 22, 2011 7:46 pm

Post by siempre.aprendiendo
Tue Feb 22, 2011 7:46 pm

Which is and where is (in the humanoid) the Bluetooth sender/receiver?
Which is and where is (in the humanoid) the Bluetooth sender/receiver?
siempre.aprendiendo
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 559
Joined: Wed Aug 08, 2007 9:13 pm
Location: Barcelona
Top

simple

Post by UncleBob » Wed Feb 23, 2011 9:55 am

Post by UncleBob
Wed Feb 23, 2011 9:55 am

Just start all program at the same time using a controller should also do the trick.
Just start all program at the same time using a controller should also do the trick.
UncleBob
Savvy Roboteer
Savvy Roboteer
Posts: 398
Joined: Sun Dec 27, 2009 5:25 am
Top

5 posts • Page 1 of 1
Post a reply
5 posts • Page 1 of 1
Return to Bioloid & Robotis