Notify: "A file motion cannot play Next/Exit pages.....
Notify: "A file motion cannot play Next/Exit pages.....
by aacs
Wed Sep 21, 2011 9:51 pm
Hi all,
I just got a Comprehensive Kit from my friend and I am trying to create a walking gait for it. I downloaded the latest RoboPlus (V1.0.23.0), updated the Firmware and used the Motion utility to create the poses. I then hit "Downloaded" and hit "Play Motion". I instantly get this message: "A file motion cannot play Next/Exit pages. To execute all motions, they must be downloaded to the robot...". But, I thought I already did that! What's going on? How am I gonna be able to run the MTN file that I created? My aim is to run the robot on its own, but when I disconnect the wires and hit the "Play" button, TXD light blinks and then stays lit, and nothing happens! What am I doing wrong here?
Thanx,
Al
I just got a Comprehensive Kit from my friend and I am trying to create a walking gait for it. I downloaded the latest RoboPlus (V1.0.23.0), updated the Firmware and used the Motion utility to create the poses. I then hit "Downloaded" and hit "Play Motion". I instantly get this message: "A file motion cannot play Next/Exit pages. To execute all motions, they must be downloaded to the robot...". But, I thought I already did that! What's going on? How am I gonna be able to run the MTN file that I created? My aim is to run the robot on its own, but when I disconnect the wires and hit the "Play" button, TXD light blinks and then stays lit, and nothing happens! What am I doing wrong here?
Thanx,
Al
Last edited by aacs on Thu Sep 22, 2011 8:55 am, edited 1 time in total.
Re: Notify: "A file motion cannot play Next/Exit pages.
by aacs
Thu Sep 22, 2011 8:54 am
Gentlemen,
I've found the answer:
After the "Download", I needed to switch on the "CM-5" TAB !!!
It then worked as expected.
FYI,
Al
I've found the answer:
After the "Download", I needed to switch on the "CM-5" TAB !!!
It then worked as expected.
FYI,
Al