Humanoid:ID13-BEEP-SMELL-Cont.Running
Humanoid:ID13-BEEP-SMELL-Cont.Running
by BioStef
Wed Nov 08, 2006 7:35 pm
Hello,
i just worked with the Motion Editor for 10 Minutes today.I made a
Grab/Put down Motion with a 100gr Ball.When my Humanoid stand
upright like original Motion 1,i suddenly listened a Beep , got the smell
of Burning Electronics and my little Beast kicks his A.... himself.I turned
him off and took a closer look.The smell came from Servo 13 but he wasn't hot, just warm as the other Servos.When i switched the Robot On again ID 13 starts to run like in Continous Mode and didn't stop anymore.
When i use the Motion Editor and ID13 is switched on he stop running but as soon as i disable him,he's running again....
I used only him at CM5 but no change..........
Is he KILLED by me......or maybe is it some kind of Manufactoring Error ?
(Warranty?-just 4 Weeks old!)
So far he was working very well.I replaced it with a Arm Servo and my
Robot works fine again...............
So i need some advice now.Help me Please !!!!!!!!
i just worked with the Motion Editor for 10 Minutes today.I made a
Grab/Put down Motion with a 100gr Ball.When my Humanoid stand
upright like original Motion 1,i suddenly listened a Beep , got the smell
of Burning Electronics and my little Beast kicks his A.... himself.I turned
him off and took a closer look.The smell came from Servo 13 but he wasn't hot, just warm as the other Servos.When i switched the Robot On again ID 13 starts to run like in Continous Mode and didn't stop anymore.
When i use the Motion Editor and ID13 is switched on he stop running but as soon as i disable him,he's running again....
I used only him at CM5 but no change..........
Is he KILLED by me......or maybe is it some kind of Manufactoring Error ?
(Warranty?-just 4 Weeks old!)
So far he was working very well.I replaced it with a Arm Servo and my
Robot works fine again...............
So i need some advice now.Help me Please !!!!!!!!
