Connectors on the RX and AX Dynamixels

[Naitsirhc]

Hello,

my name is Christian and I´m new to the Robotis topic. I want to use 2 Dynamixel servos for a non-robotic application. Therefore I have to use longer cables than the ones available in the Dynamixel shops. I could buy some connecting cables and just lengthen them by soldering in longer wires but I want to do it properly and buy some connectors and make the connecting cables myself.
So does anybody know where I can find the 3 an 4 pin connectors that fit for the Dynamixel servos? My search was unsuccessful so far.

Thank you for your help!

Christian

[i-Bot]

The connectors are the Molex micro spox range 50-37-5xx3

You may need to shop around distributors for stock and the price varies a lot on different parts.

The receptacles are:
http://www.farnell.com/datasheets/84570.pdf

http://uk.farnell.com/molex/50-37-5033/ ... dp/9979557
http://uk.farnell.com/molex/50375043/cr ... dp/9979565

The pins are:

http://docs-europe.electrocomponents.co ... d8eab8.pdf

http://uk.rs-online.com/web/p/products/ ... 4E4F4E4526

You will need a small crimp tool to make them properly:

[Naitsirhc]

Now that was quick! Thanks a lot!!!
I noticed that I will also need a new power-wire for the CM-700 controller. Do you know what connector is used there?

Thanks again!

Christian

[i-Bot]

I took a look around for the supplier of the power connector and I think it is this made by YeonHo and part SMAW250-02P for the socket and 25048hs-02 for the plug.

Sadly I was unable to find a distributor or stockist of these.