setting Library Environment in AVR Studio for CM-700

[adamsya]

Hi,

I have CM-700 controller and two sensor that are flexiforce and PING))).. this two sensor will be mount to Crustcrawler AX-18A arm bot

So I have to use embedded C winAVR

I have download latest WINAVR 20100110 and AVR studio 5.1

Then I refer instruction below:
http://support.robotis.com/en/software/embeded_c/cm510_cm700/quickstart/etc_preparation.htm

But I dont know how to set the library environment because Cannot find project - Configuration Options
?
Is the example in url above show picture of AVR studio 4?

Can someone guide me please..

thanks~

[adamsya]

Btw have someone ever try PING sensor at CM-700 or atmel2561.. could you give me some sampe program pleasee~~

[Fritzoid]

adamsya,

You should be able to adapt the code used by arduino programmers to drive a PING))) sensor. Take a look at http://arduino.cc/en/Tutorial/Ping?from=Tutorial.UltrasoundSensor to see an example of the high-level code they use. The source code for the low-level routines such as pulseIn and delayMicroseconds would have to be cribbed as well.

[adamsya]

@aa

[adamsya]

Thanks Fritzoid,

is arduino use atmel microcontroller and AVR compiler? sorry i never use arduino before..

btw do you know how to set the AVRstudio library environment for cm700?

[adamsya]

Thanks Fritzoid,

is arduino use atmel microcontroller and AVR compiler? sorry i never use arduino before..

btw do you know how to set the AVRstudio library environment for cm700?