Roboplus motion problem
Roboplus motion problem
by domatik
Fri Aug 24, 2012 2:42 am
Hi everyone!!
I have a problem with my roboplus motion.
A week ago I had to restore the firmware of 3 dynamixels.
When I try to control any dynamixel with the roboplus motion all of the motors go to 0 or 1023.
The only motor that works fine is ID 1.
If I change any motor to the ID 1 it responds perfect to the roboplus motion. But when I change the ID back again It just goes to a 0 or 1023 value.
Could you help me please?!?!?
Thank you!!!
I have a problem with my roboplus motion.
A week ago I had to restore the firmware of 3 dynamixels.
When I try to control any dynamixel with the roboplus motion all of the motors go to 0 or 1023.
The only motor that works fine is ID 1.
If I change any motor to the ID 1 it responds perfect to the roboplus motion. But when I change the ID back again It just goes to a 0 or 1023 value.
Could you help me please?!?!?
Thank you!!!
by siempre.aprendiendo
Fri Aug 24, 2012 6:30 am
Have you tried to restore theur default values with the Roboplus manager? http://support.robotis.com/en/software/ ... r_main.htm
Roboplus motion problem
by domatik
Tue Aug 28, 2012 4:48 am
Thank you for answering.
I have already solve the problem.
In case anyone has it you have to go to the roboplus motion.
Robot -> Edit Motion Offset.
Click Initialize and Save.
And everything is working fine.
I have already solve the problem.
In case anyone has it you have to go to the roboplus motion.
Robot -> Edit Motion Offset.
Click Initialize and Save.
And everything is working fine.