Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

brackets ... newbie question

Discussions regarding building a walking robot at home. Most of the robots participating at Robo-One competitions are custom fabricated.
2 posts • Page 1 of 1
Post a reply
2 posts • Page 1 of 1

brackets ... newbie question

Post by vbot » Sun Nov 04, 2007 8:10 pm

Post by vbot
Sun Nov 04, 2007 8:10 pm

I've seen a few robot erector sets out there (such as at Lynxmotion) and got me wondering... Is anyone making brackets that fit the HSR-8498HB servos beyond those for the RN1? I couldn't tell if the ones lynxmotion carried would work.. Didn't look like it to me. I'm capable of making custom ones but if I can grab appropriate ones for a few bucks instead...
:wink:

Also, is there a source for RN1 brackets sold individually?

Thanks!
I've seen a few robot erector sets out there (such as at Lynxmotion) and got me wondering... Is anyone making brackets that fit the HSR-8498HB servos beyond those for the RN1? I couldn't tell if the ones lynxmotion carried would work.. Didn't look like it to me. I'm capable of making custom ones but if I can grab appropriate ones for a few bucks instead...
:wink:

Also, is there a source for RN1 brackets sold individually?

Thanks!
vbot
Newbie
Newbie
Posts: 3
Joined: Sat Nov 03, 2007 10:17 am
Top

Post by bbrainmonkey » Fri Nov 09, 2007 12:29 am

Post by bbrainmonkey
Fri Nov 09, 2007 12:29 am

RN-1 brackets are sold under the robonova section of lynxmotion.

Hope this helps!
RN-1 brackets are sold under the robonova section of lynxmotion.

Hope this helps!
bbrainmonkey
Savvy Roboteer
Savvy Roboteer
Posts: 36
Joined: Thu Nov 08, 2007 3:34 am
Location: Connecticut
Top

2 posts • Page 1 of 1
Post a reply
2 posts • Page 1 of 1
Return to Home Built