RoboSavvy Forum • View topic - What would be a good Servo?

Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

What would be a good Servo?

3 posts • Page 1 of 1

Post a reply

3 posts • Page 1 of 1

What would be a good Servo?

by NewBreedWarrior » Sun Sep 17, 2006 3:30 am

by NewBreedWarrior
Sun Sep 17, 2006 3:30 am

Wanting to build my custom bi-ped...I allready have a robonova w/ 2 extra dof thats 18 so far with the HSR-8498hb servo of hitec should I just stick with those guy's. Then again should I switch to better ones all sugestions are welcome and opinion's thanks

In the fell clutch of circumstance
I have not winced nor cried aloud.
Under the bludgeonings of chance
My head is bloody, but unbowed.

NewBreedWarrior

Savvy Roboteer

Posts: 53

Joined: Fri Jul 28, 2006 1:00 am

Location: United States, Kentucky

Top

by Robo1 » Thu Sep 28, 2006 12:15 pm

by Robo1
Thu Sep 28, 2006 12:15 pm

I would use beter servos like the robotis dx 117

this is because there daisy chain an can give feed back for temp, voltage current and position and are 40 kg/cm

bren